WDTC-01big transformer winding machine Flat wire winding machine Large torsion winding machine Air Coil Winding Machine for Self bonding wire Cnc single spindle winding machine Computer controlled general transformer and bobbin winder with single winding heads. Recommended for wire gauge 38-9...Send Inquiry
WDTC-01HT winding machine
big transformer winding machine
Flat wire winding machine
Large torsion winding machine
Air Coil Winding Machine for Self bonding wire
Cnc single spindle winding machine
Computer controlled general transformer and bobbin winder with single winding heads. Recommended for wire gauge 38-9
For Up To 150KVA Transformer
Size of wound conductor
Center height over table/bench
More taper tail stock
Dimension of equipment(LXWXH)
Spanner,felt and others
0-1200rpm (customizable to 6000rpm)
Winding wire diameter
Winding coil diameter
• Keyless Chuck Adapter – Tooling (1 required)
Winding machine advantages
1. The use of independent bearing design, toothed belt replacement quick and easy.
2. Power-off save winding data, effectively avoid scrap coil.
3. wind to bobbin end side, intelligent deceleration, can fast winding thick wire.
4. Machine can automatic measure out the start winding data and winding width.
5. Can set the spindle climb time, you can set the winding speed up and down when the machine winding.
6. Full-English touch screen display, the operation more convenient and quick.
7. Using 32-bit ARM control chip controller, faster computing speed, effectively reducing the cable error.
8. All optical input and output isolation, work stability.
9. The use of Japan imported bearings, belts, Taiwan imported inverter and screw to ensure stable performance.
•ENTIRE WINDING PROGRAM ENTERED INTO COMPUTER IN A SIMPLE MANNER
•PROGRAMS INCLUDE TURNS, WIRE PITCH AND WINDING SPEED WITH SLOW START AND FINISH
•4 QUICKLY CHANGED SPEED TORQUE RANGES UP TO 6,000 RPM FOR WIDE RANGE OF WIRE SIZES
AND TORQUE REQUIREMENTS
•DIFFERENT COIL INSTRUCTIONS CAN BE STORED IN COMPUTER MEMORY AND QUICKLY CALLED
UP BY OPERATOR
•ELECTRONIC CONTROLLED TRAVERSE WITH STEPPING MOTOR DRIVE
•MOST FEATURES INCLUDED AS STANDARD EQUIPMENT AT REMARKABLY LOW COST
•FOOT SWITCH STANDARD
•SIMPLIFIED OPERATOR INSTRUCTION
•ELECTRIC BRAKE STANDARD
•MANUAL FOR STEP-BY-STEP PROCEDURES
Scope of application:
Suitable for high-frequency transformers winding, low-frequency transformers winding, inductors winding and other coils winding.
Instructions for use:
1.Please use 220V ± 10% / 50HZ power supply.
2.Do not place the device in a strong electromagnetic interference environment.
3.Equipment should be -10 ℃ -40 ℃ 95% RH non-condensing environment use.
4.Main circuit board is susceptible to electrostatic damage and damage, do not touch the main circuit board.
5.Do not start and shut down the power frequently, turn off the power after 10 seconds before starting.